Co-developed a commercial series of six guitar effect pedals that run on 3 V, from DipTrace PCB layouts through a shared enclosure drill template and laser-engraved artwork on 75 powder-coated 1590B enclosures, then sold the finished series at a trade show.
6 pedals 3 V supply 75 enclosures
Clean Boost, Compressor, Distortion (the Drippstortion), Fuzz, Phaser, and Tremolo: a complete pedal line, built to sell. Every circuit runs from a 3 V supply, so the designs are built around rail-to-rail CMOS op-amps (Microchip MCP606x and MCP6V64) and, in the Tremolo, zero-threshold ALD110900 MOSFETs.
All six share the same 1590B aluminum enclosure and control layout: two knobs, two toggles, a status LED, and a footswitch. The PCB layouts place the pots, toggles, and LED to line up with one drilling pattern, and each pedal's artwork was laser-engraved onto the powder-coated lid.
The finished series was exhibited and sold at a trade show.
DipTrace layouts, rendered here straight from the original Gerber and drill files. The Tremolo went through two board revisions before production.
The Drippstortion started as a large prototype board with five controls (Input, Lo-cut, Hi-cut, FF cut, and Output) plus a three-way Hard Clip / Clean / Soft Clip switch.
The production pedal brings that down to two knobs and two toggles on a board that fits the 1590B, the same control layout used across the whole series.
Every circuit runs from 3 V. The parts list is built around rail-to-rail CMOS op-amps (MCP6064, MCP6062, MCP6061, MCP6V64), an MCP6541 comparator, and zero-threshold ALD110900 MOSFETs in the Tremolo.
Iterated the Tremolo board from Rev A (March 2021) to Rev B (May 2021), adding a bottom-layer copper pour and cutting the drilled holes from 192 to 106.
Placed potentiometers, toggles, and LEDs in the PCB layouts so they line up with the enclosure drilling pattern shared across all six pedals.
Drew the 1590B lid's hole pattern as a fully constrained FreeCAD sketch: two pots, two toggles, the status LED, and the footswitch, all dimensioned from the centerline.
Operated a CNC laser to engrave custom artwork for six pedals onto 75 powder-coated aluminum enclosures, keeping each logo inside a measured band between the LED and footswitch.
Brought the series to market by exhibiting and selling the finished pedals at a trade show.